ZM100 Multi Fuel ‘Waste Oil’ Heater 8-30Kw 102,500 BTU

ZM100 Multi Fuel ‘Waste Oil’ Galvinised Heater 8KW – 30KW 102,500 BTU for Workshops, Garages & Industrial Units

The ZM100 multi-fuel cabinet heater, is ideal for workshops, garages, warehouses, agricultural buildings and a range of other industrial spaces. It can be fuelled using bio oil, bio diesels and various vegetable oils, rapeseed oil, linseed oil, as well as waste oil and standard diesel or red diesel. The ZM100 is a very high-efficiency heater with an open flame combustion chamber that delivers 8-30Kw of heat (102,500 BTU/HR) of radiant heat, with its 3 stage heat output and also moves 1,400m3 per hour of warm air via the vents thanks to blower fan at the top of the unit and is recommended for workshops where no explosive vapours are present.

The unit also features an LED control panel which quickly shows the operating mode of the heater and generates heat from a wide range of oil based fuels including used engine oils, gear oils, hydraulic oils, as well as heating oil, red diesel / diesel. The unit is supplied with a draft stabiliser for connection to the 130mm flue, the unit is available with or without a flue kit. This heater is made in the EU and fully CE approved with full UK support. Safety features including overheat, overflow and burner tray spill protection offer complete peace of mind.

Key Features:

• Up to 102,500 Btu/hr
• 8kW/hr – 30kW/hr – 52kW/hr

• COST EFFECTIVE!
• LOW RUNNING COSTS!
• CLEAN FREE HEAT!

FUELS THAT CAN BE USED

• Vegetable oils (biofuels)
• Raw vegetable oils (rapeseed, sunflower, and others), including post-frying (gastronomy)
• Mineral oils (used engine, gear, hydraulic and diesel oils of HBO I, II, III type with a viscosity not higher than SAE80)
• Heating oil

SUITABLE FOR SMALL WORKSHOP

(Delivery & Installation)
After any purchase, all customers are contacted by the ZM Customer Service Team, to coordinate your delivery and the pre install technical checks